OpenVZ Forum


Home » General » Support » *SOLVED* Hardware Drivers
Re: Hardware Drivers [message #6037 is a reply to message #6036] Thu, 07 September 2006 06:18 Go to previous messageGo to previous message
tiggerific is currently offline  tiggerific
Messages: 8
Registered: September 2006
Junior Member
Well now I'm going to show how little knowledge I have when it comes to kernels and hardware ...

1. I do know how to restart the network, this is not a problem.
2. If I can't get access to the network whenever the kernel I want is loaded, then I can't actually test your theory (I only have SSH access).
3. I've never used modprobe and have no idea how to use it.
4. From my looking around, I also believe this is the problem that the correct module isn't loaded - but the only time it isn't loaded appears to be when the OpenVZ kernel is booted. Is there something missing from my kernel config or something that is in the other configs, that will make sure this module will load.

I have looked through various .config files and such and found where the 8139TOO module is enabled but I can't tell whether it's right or not, so I haven't touched anything there.

Thanks so much for your help so far.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Having to create /dev/vzctl after every reboot?
Next Topic: *SOLVED* multiples interfaces ?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Aug 25 11:00:43 GMT 2026

Total time taken to generate the page: 0.45964 seconds
Powered by FUDforum Powered by Virtuozzo Containers