OpenVZ Forum


Home » General » Support » *SOLVED* Multiple IP - Speed?
Re: Multiple IP - Speed? [message #5987 is a reply to message #5983] Wed, 06 September 2006 11:19 Go to previous messageGo to previous message
Andrey Mirkin is currently offline  Andrey Mirkin
Messages: 193
Registered: May 2006
Senior Member
So, you have one ethernet interface on HW node and you want to use minimal set of IP addresses.
Next veth with birdge configuration can helps you:

1. Create veth device for your VPS (See http://wiki.openvz.org/Virtual_Ethernet_device#Simple_config uration_with_virtual_ethernet_device)
2. Join veth and eth0 device in one bridge on HW node
3. Assign HW node IP address to created bridge and change all routes on HW node accordingly
4. Assign appropriate IP address to eth0 in VPS

In this configuration you will use only 2 IP addresses. And you will not need to configure source based routing with different tables at all. Smile

Feel free to ask any question if you will have some difficulties with such configuration.

Andrey Mirkin
http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: IPV6 Support in VPS
Next Topic: Setting up VZ Partitions?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Aug 30 12:49:04 GMT 2026

Total time taken to generate the page: 0.42785 seconds
Powered by FUDforum Powered by Virtuozzo Containers