OpenVZ Forum: Discussions » Reconfiguring network from scratch

Home » General » Discussions » Reconfiguring network from scratch

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Reconfiguring network from scratch [message #52941 is a reply to message #52816]

Sun, 03 September 2017 02:29

mangust
Messages: 39
Registered: April 2008
Location: USA

Member

ifcfg- files works for me. don't forget to kill NetworkManager and ModemManager: yum erase NetworkManager work perfect for me. What &^&87(*^ is that on server OS Sad

I did em1 and em2 ... into bond:

cat <<EOT > /etc/sysconfig/network-scripts/ifcfg-em1
DEVICE=em1
ONBOOT=yes
IPV6INIT=no
MASTER=bond0
SLAVE=yes
EOT
cat <<EOT > /etc/sysconfig/network-scripts/ifcfg-em2
DEVICE=em2
ONBOOT=yes
IPV6INIT=no
MASTER=bond0
SLAVE=yes
EOT
cat <<EOT > /etc/sysconfig/network-scripts/ifcfg-em3
DEVICE=em3
ONBOOT=yes
IPV6INIT=no
MASTER=bond0
SLAVE=yes
EOT
cat <<EOT > /etc/sysconfig/network-scripts/ifcfg-em4
DEVICE=em4
ONBOOT=yes
IPV6INIT=no
MASTER=bond0
SLAVE=yes
EOT

cat <<EOT > /etc/sysconfig/network-scripts/ifcfg-bond0
DEVICE=bond0
ONBOOT=YES
BONDING_OPTS="miimon=100 mode=1"
IPV6INIT=no
EOT

Installer with Manager will try to put all your interfaces into bridges. Make sure to go and remove them from there Smile

Spend 30minutes figuring out why IP on the bond0 was not working, till figure out it was in a bridge Smile

[Updated on: Sun, 03 September 2017 02:32]

Report message to a moderator

[Message index]

		Reconfiguring network from scratch By: azilber on Tue, 25 April 2017 22:37
		Re: Reconfiguring network from scratch By: mangust on Sun, 03 September 2017 02:29

Previous Topic:	Installation over KVM/IP & Software RAID
Next Topic:	Veth Interface

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 02 07:35:50 GMT 2026

Total time taken to generate the page: 0.70821 seconds