OpenVZ Forum


Home » General » Support » How to create multiple venet interfaces on HN?
How to create multiple venet interfaces on HN? [message #51476] Mon, 23 June 2014 15:44
Ilya Evseev is currently offline  Ilya Evseev
Messages: 12
Registered: September 2006
Location: SPb, Russia~
Junior Member
By default, all CT's are attached to single common venet0 interface on HN.
How to create on HN separate venet0, venet1, ... - for each CT?
It would be useful for shaping, traffic counting, etc.

Report message to a moderator

[Message index]
 
Read Message
Previous Topic: ploop and secure /tmp
Next Topic: OpenVZ Backup
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed May 27 01:26:13 GMT 2026

Total time taken to generate the page: 0.14560 seconds
Powered by FUDforum Powered by Virtuozzo Containers