OpenVZ Forum


Home » General » Support » How to modprobe for containers?
How to modprobe for containers? [message #47711] Thu, 30 August 2012 07:13 Go to next message
yangshen is currently offline  yangshen
Messages: 3
Registered: August 2012
Junior Member
Hi Guys,

Is it possilbe we can modprobe specific modules for different containers during the installation?

For example, for a module nf_nat_ftp. may I only want it to be configured in a container, not for the whole hardware note.

I saw there was some premount action in vzctl. Can it do this? Or some other proper way.

Thanks in advance.

Yang

Report message to a moderator

Re: How to modprobe for containers? [message #47719 is a reply to message #47711] Fri, 31 August 2012 12:35 Go to previous messageGo to next message
curx
Messages: 739
Registered: February 2006
Location: Nürnberg, Germany
Senior Member
Hi,

please check man page of vzctl, esp. Section "iptables control parameters".

Bye,
Thorsten

Report message to a moderator

Re: How to modprobe for containers? [message #48219 is a reply to message #47719] Mon, 08 October 2012 03:20 Go to previous message
yangshen is currently offline  yangshen
Messages: 3
Registered: August 2012
Junior Member
Really thanks.


Yang

Report message to a moderator

Previous Topic: Some confusing about "Alloc commit" in vzmemcheck
Next Topic: nearly all memory shows as cached
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Mon Jun 15 20:33:53 GMT 2026

Total time taken to generate the page: 1.07578 seconds
Powered by FUDforum Powered by Virtuozzo Containers