| *SOLVED* Routable IP's [message #4688] |
Fri, 21 July 2006 16:59  |
mavenman
Messages: 10
Registered: April 2006
|
Junior Member |
|
|
From HOST I have added a routable IP by:
$vzctl set VEID --ipadd ###.###.###.### --save
Restarted VE
From inside VE the proper IP is there for venet0:0:
-bash-3.00# ifconfig
<---- snipped lo ---->
venet0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:127.0.0.1 P-t-P:127.0.0.1 Bcast:0.0.0.0 Mask:255.255.255.255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
venet0:0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:###.###.###.### P-t-P:###.###.###.### Bcast:###.###.###.### Mask:255.255.255.255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
From HOST ifconfig venet0:
venet0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:3 errors:0 dropped:0 overruns:0 frame:0
TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:252 (252.0 b) TX bytes:252 (252.0 b)
Do I need to map the routable IP to eth0 or manually add another venet interface for the routable IP that is set for the VE?
The symptom is I am unable to reach the VE outside of the HOST. I can trace to the box but then it dies without a response from the box. If I map to eth0:1 it pings/traces but does not route the traffic to the VE it is set to.
Thanks for any help on clearing this up.
[Updated on: Sat, 22 July 2006 04:45] by Moderator Report message to a moderator |
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
