OpenVZ Forum: Support » Dual veth interfaces

Home » General » Support » Dual veth interfaces

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Dual veth interfaces [message #4622 is a reply to message #4613]

Tue, 18 July 2006 17:43

foxxfiles
Messages: 12
Registered: July 2006

Junior Member

Hi.

The logic is this you say. but i dont know where i am fail.

look.

host-node# ifconfig veth101.0 0
host-node# ifconfig veth101.1 0
host-node# echo 1 > /proc/sys/net/ipv4/conf/veth101.0/forwarding
host-node# echo 1 > /proc/sys/net/ipv4/conf/veth101.0/proxy_arp
host-node# echo 1 > /proc/sys/net/ipv4/conf/veth101.1/forwarding
host-node# echo 1 > /proc/sys/net/ipv4/conf/veth101.1/proxy_arp
host-node# echo 1 > /proc/sys/net/ipv4/conf/eth0/forwarding
host-node# echo 1 > /proc/sys/net/ipv4/conf/eth0/proxy_arp
host-node# echo 1 > /proc/sys/net/ipv4/conf/eth1/forwarding
host-node# echo 1 > /proc/sys/net/ipv4/conf/eth1/proxy_arp

test-vps# /sbin/ifconfig eth0 0
test-vps# /sbin/ifconfig eth1 0
test-vps# /sbin/ip addr add 200.25.96.2 dev eth0
test-vps# /sbin/ip addr add 192.168.156.252 dev eth1
test-vps# /sbin/ip ro add 192.168.156.0/24 dev eth1
test-vps# /sbin/ip route add default dev eth0

host-node# /sbin/ip route add 192.168.156.252 dev veth101.1
host-node# /sbin/ip route add 200.25.96.2 dev veth101.0

After This on other host 2 interfaces with communication on 2 Networks.

fox@otherhost:~$ ping 192.168.156.252
PING 192.168.156.252 (192.168.156.252) 56(84) bytes of data.
From 192.168.156.5 icmp_seq=2 Destination Host Unreachable
From 192.168.156.5 icmp_seq=3 Destination Host Unreachable
From 192.168.156.5 icmp_seq=4 Destination Host Unreachable

--- 192.168.156.252 ping statistics ---
6 packets transmitted, 0 received, +3 errors, 100% packet loss, time 5010ms
, pipe 3

fox@otherhost:~$ ping 200.25.96.2
PING 200.25.96.2 (200.25.96.2) 56(84) bytes of data.
64 bytes from 200.25.96.2: icmp_seq=1 ttl=64 time=0.045 ms
64 bytes from 200.25.96.2: icmp_seq=2 ttl=64 time=0.035 ms

--- 2200.25.96.2 ping statistics ---
2 packets transmitted, 2 received, 0% packet loss, time 1000ms
rtt min/avg/max/mdev = 0.035/0.040/0.045/0.005 ms

Only work the interface with the default gw on VPS.
Iam omit some step?
Howto make Work this.

Fernando

Report message to a moderator

[Message index]

		Dual veth interfaces By: foxxfiles on Mon, 17 July 2006 19:20
		Re: Dual veth interfaces By: Andrey Mirkin on Tue, 18 July 2006 08:57
		Re: Dual veth interfaces By: foxxfiles on Tue, 18 July 2006 17:43
		Re: Dual veth interfaces By: Andrey Mirkin on Wed, 19 July 2006 08:41
		Re: Dual veth interfaces By: foxxfiles on Wed, 19 July 2006 21:02
		Re: Dual veth interfaces By: Andrey Mirkin on Fri, 21 July 2006 08:36
		Re: Dual veth interfaces By: foxxfiles on Fri, 21 July 2006 19:50
		Re: Dual veth interfaces By: Andrey Mirkin on Tue, 25 July 2006 12:16
		Re: Dual veth interfaces By: foxxfiles on Tue, 01 August 2006 16:07
		Re: Dual veth interfaces By: Andrey Mirkin on Wed, 02 August 2006 11:42
		Re: Dual veth interfaces By: AngelMC on Tue, 18 July 2006 09:49

Previous Topic:	SOLVED Networking Issue
Next Topic:	VE "route" command shows 191.255.255.1

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jun 14 13:35:18 GMT 2026

Total time taken to generate the page: 0.35252 seconds