OpenVZ Forum: Support » can't load ipv6 module due to service vz is started

Home » General » Support » can't load ipv6 module due to service vz is started

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

can't load ipv6 module due to service vz is started [message #43937]

Tue, 01 November 2011 04:26

siterack_net
Messages: 4
Registered: August 2010

Junior Member

After a recent kernal update on a HyperVM node running centos 5.7 I am constantly getting "can't load ipv6 module due to service vz is started" in the console terminal.

It does not appear to be affecting server operation, but it's rather annoying.
sysctl.conf has no ipv6 instructions in it
vz.conf has ipv6 disabled

Kernal = 2.6.18-274.3.1.el5.028stab094.3 x86_64

Report message to a moderator

Re: can't load ipv6 module due to service vz is started [message #43938 is a reply to message #43937]

Tue, 01 November 2011 11:24

Electron
Messages: 7
Registered: November 2011

Junior Member

Problem exist and on my server ( CentOS 5 ) with the same kernel.

Kernel = 2.6.18-274.3.1.el5.028stab094.3 x86_64

Report message to a moderator

Re: can't load ipv6 module due to service vz is started [message #44104 is a reply to message #43937]

Wed, 16 November 2011 15:37

swindmill
Messages: 57
Registered: April 2007

Member

I too have seen this issue on one of my host nodes after upgrading to CentOS 5.7 and 2.6.18-274.el5.028stab093.2

Report message to a moderator

Re: can't load ipv6 module due to service vz is started [message #44151 is a reply to message #44104]

Tue, 22 November 2011 04:12

alexmartin
Messages: 2
Registered: September 2011

Junior Member

Same error appears on 2.6.18-274.3.1.el5.028stab kernel only and there is no issues on other kernels. Even the ipv6 has been disabled on network file and modprobe.conf file too. Some one Openvz staff need to look into this immediately and release update for this issue.

Report message to a moderator