Hi all, I have installed Proxmox on a VPS host with a public IP. I have then setup a container and given it a public ip and it is accessible online but SSH (at least) does not work and I gather this is because the connection should be bridged... But I cannot find the method of bridging that suits this environment.
the default etc/network/interfaces looks like this.
# network interface settings
auto lo
iface lo inet loopback
iface eth0 inet manual
auto vmbr0
iface vmbr0 inet static
address 115.61.21.5
netmask 255.255.252.0
gateway 115.61.21.254
bridge_ports eth0
bridge_stp off
bridge_fd 0
But how should it look? The manual states this but it is just crashing the config:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet static
address 115.61.21.5
netmask 255.255.255.0
gateway 115.61.21.55
post-up echo 1 > /proc/sys/net/ipv4/conf/eth0/proxy_arp
auto vmbr0
iface vmbr0 inet static
address 115.61.21.6
netmask 255.255.255.0
bridge_ports none
bridge_stp off
bridge_fd 0
I have seen dozens of ways this is done but I'm stuck as to what is to be bridged and whether there's other files that need to be changed and where the containers point too. Help appreciated!
[Updated on: Sat, 26 November 2011 09:32]
Report message to a moderator
OpenVZ Forum
Members
Search
Help
Register
Login
Home
