OpenVZ Forum


Home » General » Support » Heartbeat configuration for OpenVZ's VE
Re: Heartbeat configuration for OpenVZ's VE [message #43431 is a reply to message #43424] Fri, 09 September 2011 11:29 Go to previous messageGo to previous message
seanfulton is currently offline  seanfulton
Messages: 105
Registered: May 2007
Senior Member
We use heartbeat to pair more than 50 nodes. I compared my config to yours. I have bcast commented out, and I have two ucast entries, both venet0 but one for each IP in the cluster (ie, local IP and remote IP). We have have a ping_group of four IP addresses to try to avoid deadlock.

The messages from your /var/log/messages file, the only one I think is relevant is about the response taking too long. That means that this node is not getting a response from the remote node quickly enough. Operation not permitted stuff--I have been getting that for four years; no idea what it means, but it doesn't affect heartbeat.

Can you post your haresources file?

Also, make sure the files are *identical* between the two hosts.

sean

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: How to install OpenVZ on CentOS 6
Next Topic: /dev/shm missing from fedora-15-x86 template
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Jul 16 21:43:37 GMT 2026

Total time taken to generate the page: 0.12365 seconds
Powered by FUDforum Powered by Virtuozzo Containers