OpenVZ Forum: Support » ovz-web-panel, change FDQN before installation?

Home » General » Support » ovz-web-panel, change FDQN before installation?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

ovz-web-panel, change FDQN before installation? [message #43047]

Mon, 11 July 2011 08:55

Fredrik-s
Messages: 1
Registered: July 2011

Junior Member

Hello,

I'm trying to install ovz-web-panel on Debian 6.0 64-bit.

I have installed all the necessary components:

Ruby 1.8.5+ (1.9 is not supported)
RubyGems
Ruby SQLite3 support

But after installation of ovz-web-panel through the command:
[i]wget -O - http[I-cannot-use-links-yet]://ovz-web-panel.googlecode.com/svn/installer/ai.sh | sh[/i]

It tells me that the login adress to my control panel is http[I-cannot-use-links-yet]://myserver:3000 and not http[I-cannot-use-links-yet]://myip:3000

Is it necessary to change FDQN before installation in /etc/hosts? And if it is, what should I change to. I'm pretty new to all this, so I'm a little bit confused.

Greetings

Report message to a moderator

Re: ovz-web-panel, change FDQN before installation? [message #43050 is a reply to message #43047]

Mon, 11 July 2011 13:58

Ales
Messages: 330
Registered: May 2009

Senior Member

Ovz-web-panel is a third party project. While some other user who uses it and frequents here might know the answer to your question, you'll have a better chance of getting a proper answer at ovz-web-panel forum or mailing list (if they have them).

Report message to a moderator

Previous Topic:	Wild clock fluctuation within container
Next Topic:	Problem checkpointing OpenVZ VMs under Xen

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Oct 20 19:39:49 GMT 2026

Total time taken to generate the page: 0.67376 seconds