Plesk 8 - Fedora Core 4 - Hostname Issue [message #3128] |
Sat, 13 May 2006 08:04 |
pnet
Messages: 1 Registered: May 2006
|
Junior Member |
|
|
I've got two questions.
1. How could a program supported by SW-Soft, not correctly support the installation of an SW-Soft product?
2. Does anyone have a fix for the Plesk 8 error related to "Hostname verification"?
I'm guessing this has something to do with the fact that, openVZ creates a "hosts" file in the form of:
127.0.0.1 host.domain.com host localhost localhost.localdomain
Rather than traditional setup of:
127.0.0.1 localhost localhost.localdomain
<public_ip_here> host.domain.com host
Thanks in advance for any assistance, as I'd really like to use openVZ, but need to ensure that it'll support at least Plesk.
***********
* UPDATED *
***********
I stand corrected. After doing some more messing around, all it took was to change the "hosts" file, with the "traditional" style.
Additionally, I needed to register in DNS the "host.domain.com" entry to point to "<public_ip_here>". Once this was completed, the installation via the "autoinstaller" completed without issue.
Hope this helps others in the same situation.
[Updated on: Sat, 13 May 2006 08:36] Report message to a moderator
|
|
|
|
|
|
|
|
Re: Plesk 8 - Fedora Core 4 - Hostname Issue [message #4175 is a reply to message #4149] |
Fri, 30 June 2006 16:47 |
weycresto
Messages: 17 Registered: September 2005 Location: London
|
Junior Member |
|
|
Hello
I mean't to say that Virtuozzo starts from just 3 VPS licence and single CPU. I tend to run my infrastucture servers within OpenVZ (DNS, mail etc...). Also had quite a bit of success migrating older legacy servers (RH 7.3/RH9 etc..) to virtual instances in OpenVZ. Just copy / /bin /usr /sbin etc over, create a conf file, assign an IP and boot!
BestRegards
Paul Lee
www.weycrest.co.uk
|
|
|