OpenVZ Forum


Home » Mailing lists » Devel » [patch 1/4] Network namespaces: cleanup of dev_base list use
Re: Network namespaces a path to mergable code. [message #4126 is a reply to message #4123] Thu, 29 June 2006 00:25 Go to previous messageGo to previous message
ebiederm is currently offline  ebiederm
Messages: 1354
Registered: February 2006
Senior Member
Daniel Lezcano <dlezcano@fr.ibm.com> writes:

> Andrey Savochkin wrote:
>
>> Ok, fine.
>> Now I'm working on socket code.
>> We still have a question about implicit vs explicit function parameters.
>> This question becomes more important for sockets: if we want to allow to use
>> sockets belonging to namespaces other than the current one, we need to do
>> something about it.
>> One possible option to resolve this question is to show 2 relatively short
>> patches just introducing namespaces for sockets in 2 ways: with explicit
>> function parameters and using implicit current context.
>> Then people can compare them and vote.
>> Do you think it's worth the effort?
>>
>
> The attached patch can have some part interesting for you for the socket
> tagging. It is in the IPV4 isolation (part 5/6). With this and the private
> routing table you will probably have a good IPV4 isolation.
> This patch partially isolates ipv4 by adding the network namespace
> structure in the structure sock, bind bucket and skbuf.

Ugh. skbuf sounds very wrong. Per packet overhead?

> When a socket
> is created, the pointer to the network namespace is stored in the
> struct sock and the socket belongs to the namespace by this way. That
> allows to identify sockets related to a namespace for lookup and
> procfs.
>
> The lookup is extended with a network namespace pointer, in
> order to identify listen points binded to the same port. That allows
> to have several applications binded to INADDR_ANY:port in different
> network namespace without conflicting. The bind is checked against
> port and network namespace.

Yes. If we don't duplicate the hash table we need to extend the lookup.

> When an outgoing packet has the loopback destination addres, the
> skbuff is filled with the network namespace. So the loopback packets
> never go outside the namespace. This approach facilitate the migration
> of loopback because identification is done by network namespace and
> not by address. The loopback has been benchmarked by tbench and the
> overhead is roughly 1.5 %

Ugh. 1.5% is noticeable.

I think it is cheaper to have one loopback device per namespace.
Which removes the need for a skbuff tag.

Eric

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: [patch 2/6] [Network namespace] Network device sharing by view
Next Topic: Re: [patch 2/6] [Network namespace] Network device sharing by view
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Dec 05 03:18:19 GMT 2025

Total time taken to generate the page: 0.31898 seconds
Powered by FUDforum Powered by Virtuozzo Containers