OpenVZ Forum: Support » vzdump with LVM snapshot: strange input/output error

Home » General » Support » vzdump with LVM snapshot: strange input/output error (/dev/dm-10: read failed after 0 of 4096 at 0: Input/output error)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: vzdump with LVM snapshot: strange input/output error [message #39702 is a reply to message #39629]

Tue, 25 May 2010 08:53

Master One
Messages: 9
Registered: October 2007

Junior Member

Ok, that one solved the mystery:

/dev/dm-10 is a luks-encrypted disk, which has been shut off due to power-supply failure, and since that one was not hot-swap, it still shows up a active block device.

Didn't think of that, because that disk was not used for anything, and which is why I have no clue, why vzdump tries to access that drive.

Thanks, sHaggY_caT. Smile

Report message to a moderator

[Message index]

		vzdump with LVM snapshot: strange input/output error By: Master One on Sat, 22 May 2010 08:16
		Re: vzdump with LVM snapshot: strange input/output error By: sHaggY_caT on Sun, 23 May 2010 03:22
		Re: vzdump with LVM snapshot: strange input/output error By: Master One on Sun, 23 May 2010 07:29
		Re: vzdump with LVM snapshot: strange input/output error By: sHaggY_caT on Sun, 23 May 2010 07:37
		Re: vzdump with LVM snapshot: strange input/output error By: Master One on Tue, 25 May 2010 07:57
		Re: vzdump with LVM snapshot: strange input/output error By: sHaggY_caT on Tue, 25 May 2010 08:38
		Re: vzdump with LVM snapshot: strange input/output error By: Master One on Tue, 25 May 2010 08:53
		Re: vzdump with LVM snapshot: strange input/output error By: sHaggY_caT on Tue, 25 May 2010 09:24

Previous Topic:	Very Weird Problem. sometimes VE starts perfect other times is does not
Next Topic:	how to Install OpenVZ

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Jul 22 19:30:40 GMT 2025

Total time taken to generate the page: 0.22503 seconds