VETH and bridging [message #39556] |
Mon, 10 May 2010 20:28 |
radialflux
Messages: 2 Registered: May 2010 Location: Texas
|
Junior Member |
|
|
Hey all,
I am running into issues while trying to connect a single VE to 2 bridges, like so:
(Subnet is 192.168)
(20.2)Br0----[ETH0(20.1) VE (30.1)ETH1]----Br1(30.2)
If I bring up a single interface, Br0 to Eth0 it works great, but when I add ETH1 to Br1 it becomes unreachable. Any suggestions? Is this an unsupported configuration?
Thanks!
2.6.27-openvz-kiprensky.1-r1
vzctl version 3.0.23
===================
SLOPE-V1 ~ # iptables -t nat -L && iptables -t filter -L && iptables -t mangle -L
Chain PREROUTING (policy ACCEPT)
target prot opt source destination
Chain POSTROUTING (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
Chain INPUT (policy ACCEPT)
target prot opt source destination
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
Chain PREROUTING (policy ACCEPT)
target prot opt source destination
Chain INPUT (policy ACCEPT)
target prot opt source destination
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
Chain POSTROUTING (policy ACCEPT)
target prot opt source destination
[Updated on: Mon, 10 May 2010 20:44] Report message to a moderator
|
|
|