veth and venet on one hardware node [message #39510] |
Tue, 04 May 2010 07:38 |
wojtek_z
Messages: 5 Registered: May 2010
|
Junior Member |
|
|
Hi,
I have a problem with configuring veth (with dhcpd in virtual client) on hardware node with working venet.
I have hardware node with few conteiners with veneth configuration. I need another container but with veth (with dhcpd). Hardware node has two nic's in bonding (active-standby) configuration.
I create container with veth device veth155.0 and bridge br155.
bridge name bridge id STP enabled interfaces
br155 8000.000000000000 no
.
In virtual conteiner i have interface eth0 with ip addres, netmask, gateway etc.
Configuration of Hardware Node:
2.6.26-2-openvz-amd64
debian 5.0.4 - lenny
[Updated on: Wed, 05 May 2010 06:29] Report message to a moderator
|
|
|
|
|
|
|
|
Re: veth and venet on one hardware node [message #39875 is a reply to message #39865] |
Fri, 11 June 2010 21:13 |
wojtek_z
Messages: 5 Registered: May 2010
|
Junior Member |
|
|
Hi,
- iptables on HN is off
- ping from another HN didn't work
- ping from HN to VE (hosted on this HN) ok
- tcpdump from VE - no transmission
- tcpdump from HN on bridge - ok
- tcpdump from HN on physical interface - ok
It look's like no transmission between HN (venet) and VE
I checked /proc/sys/net/*
and compare with documentation.
After that I set echo 1 /proc/sys/net/ipv4/ip_forward
and all works fine
[Updated on: Fri, 11 June 2010 21:22] Report message to a moderator
|
|
|