OpenVZ Forum: Support » Disable Networking on VE, but only allow traffic from venet0:0

Home » General » Support » Disable Networking on VE, but only allow traffic from venet0:0 (Is it possible to somehow only allow networking from venet0:0, but ignore others?)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Disable Networking on VE, but only allow traffic from venet0:0 [message #39253]

Fri, 02 April 2010 16:01

EXT3FSCK
Messages: 1
Registered: April 2010

Junior Member

I am working on a cluster-able solution using openVZ.

There is one thing that I am stuck on, is I need IP addresses added to the VE , but I need for them not to be route able at all, just venet0:0 , I just need them there so scripts on the node can read the IPs. Its using a closed code control panel so no other way to modify it.

My best solution is to somehow make the VE only route traffic from venet0:0, but ignore anything else. venet0:* other than venet0:0 I want it ignored, not routeable, etc, but at least it can show when doing "ip addr show" in a CentOS template.

Is it possible somehow in openVZ to get this done ?

If so how would someone go to do this?

Report message to a moderator