OpenVZ Forum


Home » General » Support » Symlink vmbr0 to eth0? (Has anyone done it without issue)
Symlink vmbr0 to eth0? [message #39059] Wed, 10 March 2010 19:22 Go to next message
SSJGotenks
Messages: 2
Registered: March 2010
Junior Member
I have linux distro that is built on the premise that there is an eth0 being watched/used for monitoring. I have a few 3rd party update scripts also calling for eth0. I get chocked up seeing everything in red and saying offline in the default 'status' command when if only I had an eth0, it would say everything is responding.

Is there anyway to link vmbr0 for example to eth0 on CentOS?

Distro: PBX in a Flash based off CentOS 4.3

[Updated on: Fri, 12 March 2010 22:14]

Report message to a moderator

Re: Symlink vmbr0 to eth0? [message #39103 is a reply to message #39059] Mon, 15 March 2010 14:26 Go to previous message
curx
Messages: 739
Registered: February 2006
Location: Nürnberg, Germany
Senior Member
Hi,

not tested, only a idea:

- udev rule to rename eth0 to e.g. real_eth0
- brctl addbr eth0 ; brctl addif eth0 real_eth0

bye,
Thorsten

Report message to a moderator

Previous Topic: Hardware x64 - Performance
Next Topic: libvirt xml config files
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Aug 27 11:19:26 GMT 2024

Total time taken to generate the page: 0.03445 seconds
Powered by FUDforum Powered by Virtuozzo Containers