OpenVZ Forum: Support » Firewall and NAT

Home » General » Support » Firewall and NAT (Problem enabling NAT)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Firewall and NAT [message #38416]

Fri, 18 December 2009 03:49

foxb
Messages: 12
Registered: December 2009

Junior Member

Hi,

I followed the tutorial:
http://wiki.openvz.org/Setting_up_an_iptables_firewall#Setti ng_up_a_HN-based_firewall

But Now I want to enable NAT (CT to be with Private IP)

As described here:
http://wiki.openvz.org/NAT

iptables -t nat -A POSTROUTING -s 192.168.12.0/24 -o eth0 -j SNAT --to xx.xx.xx.xx
iptables -t nat -A PREROUTING -p tcp -d xx.xx.xx.xx --dport 888 -i eth0 -j DNAT --to-destination 192.168.12.12:80

But nothing happens?

No error, but when I issue iptables -L -n noting appears?!

Host is CentOS 5

It should be obvious mistake, but cannot figure it...

Any suggestions?

If additional information is needed, please let me know.

Report message to a moderator

Re: Firewall and NAT [message #38422 is a reply to message #38416]

Fri, 18 December 2009 12:50

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

# iptables -t nat -L

Report message to a moderator

Re: Firewall and NAT (Sort of solved - closed) [message #38507 is a reply to message #38422]

Mon, 28 December 2009 12:04

foxb
Messages: 12
Registered: December 2009

Junior Member

Sorry for the delay... was a bit busy

Yes that command shows the existence, but the command does not work.

I've decided to switch to shorewall since I've used it in the past + I need more advanced firewall that the one in the firewall script and it worked.

Topic closed...

Report message to a moderator

Previous Topic:	Configure virtualized /proc
Next Topic:	centos4 didn't find ovzkernel-devel, maybe give a try for el5 kernel flavor?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 29 22:59:29 GMT 2026

Total time taken to generate the page: 0.13496 seconds