OpenVZ Forum


Home » General » Support » Elastix on OpenVZ, I cant to do the bridge
Re: Elastix on OpenVZ, I cant to do the bridge [message #37896 is a reply to message #37869] Fri, 30 October 2009 12:29 Go to previous messageGo to previous message
maratrus is currently offline  maratrus
Messages: 1495
Registered: August 2007
Location: Moscow
Senior Member
Hello Augusto,


from my point of view the marked commands are erroneous

Quote:

# brctl addbr br0
# ifconfig eth0 0
# brctl addif br0 eth0
# ifconfig br0 192.168.1.125 netmask 255.255.255.0
# ip route add default via 192.168.1.1 dev br0
# ifconfig eth0 192.168.1.105 netmask 255.255.255.0
# ifconfig venet0 192.168.1.125 netmask 255.255.255.0
# vzctl start 777
# vzctl set 777 --netif_add eth0 --save
# vzctl exec 777 ifconfig eth0 192.168.1.105 netmask 255.255.255.0
# brctl addif br0 veth777.0
# vzctl exec 777 ip route add default via 192.168.1.1 dev eth0


IP addresses are not supposed to be assigned on both br0 and eth0 interfaces.
Please, read http://wiki.openvz.org/Veth#Virtual_Ethernet_devices_can_be_ joined_in_one_bridge

Just properly configure eth0 add it to bridge as well as veth777.0.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: CPULIMIT problem
Next Topic: Live migration with host file system mounted
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Sep 01 09:49:00 GMT 2026

Total time taken to generate the page: 0.36957 seconds
Powered by FUDforum Powered by Virtuozzo Containers