OpenVZ Forum


Home » General » Support » Ethernet bonding with bridge device on CentOS 5.3
Re: Ethernet bonding with bridge device on CentOS 5.3 [message #37781 is a reply to message #37779] Tue, 20 October 2009 20:03 Go to previous messageGo to previous message
ramjet is currently offline  ramjet
Messages: 16
Registered: September 2009
Junior Member
It will work the way you describe. Create a bridge device. Then add your bond0 and the veth devices of your servers to the bridge. Make sure the bridge is up - either ifconfig br0 0 or ifconfig br0 up and enable forwarding for br0 in /proc. Never had use for proxyarp. When I tried a coworker with MacOSX complained about errors messages. So be carefull with that.

Btw. are your servers going to run on the same IP subnet?

Are you going to run tagged vlan on top of the bond device? You can. Linux networking is very flexible.

Have you any iptables rules loaded on the host node? I tend not to as they complicate things.

Feel free to ask more as I'm going to make the same setup Thursday or Friday.

Report message to a moderator

[Message index]
 
Read Message icon5.gif
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: iptables v1.3.5: can't initialize iptables table `mangle': Table does not exist (do you need to insm
Next Topic: Has ext4 (prod) been backported to 2.6.27?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Jul 11 06:56:55 GMT 2026

Total time taken to generate the page: 0.58333 seconds
Powered by FUDforum Powered by Virtuozzo Containers