OpenVZ Forum


Home » General » Support » routing tables with openvz container
Re: routing tables with openvz container [message #37696 is a reply to message #37686] Sun, 11 October 2009 12:33 Go to previous messageGo to previous message
Wittiko is currently offline  Wittiko
Messages: 2
Registered: October 2009
Location: Wien
Junior Member
maratrus wrote on Fri, 09 October 2009 18:11
Hello,
but that is normal. If anything is done on the HN it might affect other containers.



i do the changes inside a container not on the hardware node

here is the situation:

---------------
|MODEM WAN ISP|
---------------
|
|
---------------- --------------------
| SWITCH |--------| FW-ROUTING SERVER|
---------------- --------------------
| |
|WAN |INTERNAL
| |
----------------
| HW Nodes |
----------------

the wan subnets go over the switch direct to the modem but for the internal networks the traffic had to go over the fw

so i need two interfaces with two default gw
i think the only way to do this is with 2 routing tables
with the containers with only one interface (only with internal address) there are no problems but with containers with 2 interfaces there are problems with the internal networks or the server is not reachable from extern

i need a solution that the traffic which come from eth0 go out over eth0 and the traffic which come from eth1 go out over eth1

eth0 and eth1 are the interfaces inside of the container

i hope you can understand the situation now

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Why umount script runs on VE start?
Next Topic: change memory ram for VE
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Sep 23 20:30:30 GMT 2026

Total time taken to generate the page: 0.55288 seconds
Powered by FUDforum Powered by Virtuozzo Containers