OpenVZ Forum


Home » General » Support » OpenVZ on Slackware64 ver. 13.0
Re: OpenVZ on Slackware64 ver. 13.0 [message #37448 is a reply to message #37416] Fri, 11 September 2009 13:52 Go to previous messageGo to previous message
maratrus is currently offline  maratrus
Messages: 1495
Registered: August 2007
Location: Moscow
Senior Member
Quote:

Q1. In order to create VFS containers using OpenVZ, is it necessary to create another partition (/dev/sda3) to place the virtual file systems?


That's not an obligatory thing to do. You may just create /vz subdirectory and that's all. But as you are using ext4 filesystem I'd earnestly recommend you to create a separate partition and format it as ext3 filesystem! It was tested and it works.

Quote:

Q2. What kernel can I recompile and use?


The already compiled kernels are available there
http://download.openvz.org/kernel/
Source may also be fetched from git:
http://git.openvz.org/

Quote:

Q3. I've been reading the hardware and software requirements for OpenVZ in the Users' Guide and if I'm understanding correctly, it can be installed in either 32 or 64-bit operating systems. Is this correct? Or do I need to install Alien Bob's "multilib" solution to allow 32 bit applications to operate on 64-bit Slackware?


Once you're using the x86_64 operating system you have to install x86_64 kernel and tools. But once you'll install them you can create 32-bit containers without any difficulties.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Previous Topic: Booting of Containers
Next Topic: vmguarpages != oomguarpages ?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Apr 16 04:25:58 GMT 2026

Total time taken to generate the page: 0.24601 seconds
Powered by FUDforum Powered by Virtuozzo Containers