| *SOLVED* Host Server eth0 failed [message #3723] |
Mon, 12 June 2006 20:34  |
mavenman
Messages: 10
Registered: April 2006
|
Junior Member |
|
|
Last night I setup a new CentOS 4.3 server for OpenVZ.
Installation went fine except the New kernel data was not automatically added to /boot/grub/grub.conf. I added it manually and changed to reflect the kernel version and set the default to the new kernel.
Updated sysctl.conf to match Install Doc.
Rebooted.
/var/log/message returned:
Jun 11 16:39:45 localhost network: Bringing up loopback interface: succeeded
Jun 11 16:39:49 localhost kernel: ACPI: PCI Root Bridge [PCI0] (00:00)
Jun 11 16:39:45 localhost ifup: b44 device eth0 does not seem to be present, delaying initialization.
Jun 11 16:39:49 localhost kernel: PCI: Probing PCI hardware (bus 00)
Jun 11 16:39:45 localhost network: Bringing up interface eth0: failed
Jun 11 16:39:49 localhost kernel: PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.1
Jun 11 16:39:49 localhost kernel: PCI: Transparent bridge - 0000:00:1e.0
Shouldn't the eth0 driver automatically be recognized? this is a dedicated server and my host did not indicate any special drivers needed for other kernels.
Are there any known issues in the kernel related to this issue?
[Updated on: Tue, 27 June 2006 10:17] by Moderator Report message to a moderator |
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
