OpenVZ Forum: Support » How to use two different eth interfaces inside CT

Home » General » Support » How to use two different eth interfaces inside CT

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to use two different eth interfaces inside CT [message #37119 is a reply to message #37087]

Wed, 19 August 2009 13:24

tomp
Messages: 64
Registered: August 2007

Member

If its a VLAN, I think you have to create a virtual bridge and then connect the VLAN interface on the hardware node to the virtual bridge.

Then create a veth device inside the container and attach that to the bridge on the hardware node.

There are some tutorials on bridging in the wiki. I don't think OpenVZ supports VLAN tagging yet, so this is your best way round it.

Report message to a moderator

[Message index]

		How to use two different eth interfaces inside CT By: Mistery on Tue, 18 August 2009 10:27
		Re: How to use two different eth interfaces inside CT By: Mistery on Wed, 19 August 2009 13:21
		Re: How to use two different eth interfaces inside CT By: tomp on Wed, 19 August 2009 13:24
		Re: How to use two different eth interfaces inside CT By: Mistery on Wed, 19 August 2009 13:29
		Re: How to use two different eth interfaces inside CT By: maratrus on Wed, 19 August 2009 15:06

Previous Topic:	Creating tun in container fails after following wiki instruction on host
Next Topic:	Sharing Shared Memory ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Sep 19 20:08:38 GMT 2026

Total time taken to generate the page: 0.12079 seconds