OpenVZ Forum: Support » OpenVPN bridhing inside VE

Home » General » Support » OpenVPN bridhing inside VE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

OpenVPN bridhing inside VE [message #36801]

Mon, 20 July 2009 21:18

divB
Messages: 79
Registered: April 2009

Member

Hi,

Has anybody tried using OpenVPN inside a VE in bridging mode?

If I call "openvpn --mktun --dev tap0" I get a "tap0" device which is only visible inside the VE. But inside the VE I can't use bridging as far as I know.

Is it somehow possible to create the device on the hardware node (and bridge it) and use it inside a VE?

divB

PS: I really need bridging because I need non-IP protocols...

Report message to a moderator

Re: OpenVPN bridhing inside VE [message #36836 is a reply to message #36801]

Wed, 22 July 2009 20:23

tomp
Messages: 64
Registered: August 2007

Member

Maybe not as secure, but you could run openvpn on hardware node and then bridge containers together onto the VPN bridge? That way you can communicate using non-IP between containers over the VPN?

Report message to a moderator

Re: OpenVPN bridhing inside VE [message #36838 is a reply to message #36836]

Wed, 22 July 2009 23:20

divB
Messages: 79
Registered: April 2009

Member

Thanks for your reply.

Yes, for now, I did exactly that. It works, but actually I really do not want to have OpenVPN running on the hardware node.

If there is any way left...I'd be very happy!

Maybe I could allocate `tap0' on the HN, bridge it approriately and somehow "export" it into a VE?! Is that possible?

Best regards,
divB

Report message to a moderator

Previous Topic:	New stable Kernel? Roadmap?
Next Topic:	Allowing web-based direct shell access?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Aug 02 08:10:29 GMT 2026

Total time taken to generate the page: 0.62598 seconds