IPSec-Server in a VPS [message #28324] |
Thu, 13 March 2008 23:31 |
schogge
Messages: 19 Registered: July 2007
|
Junior Member |
|
|
Hi all,
I would like to install a VPN-Server inside a VPS. Is that supported and if so, what needs to be done?
The wiki is talking about installing an IPSec-Client (vpnc) and also OpenVPN-Server. But I want to use an IPSec-Server like Openswan or racoon.
Thanks
schogge
|
|
|
|
|
|
|
|
Re: IPSec-Server in a VPS [message #43027 is a reply to message #37207] |
Mon, 04 July 2011 14:42 |
JohnDoe
Messages: 3 Registered: July 2011
|
Junior Member |
|
|
groka76 wrote on Wed, 26 August 2009 13:28Hi All,
I have work out configruation with Racoon.
...
The Racoon is installed in the host machine and send packet in the containter.
It needed set up a veth interface.
Ga
Hi groka76,
how did you achieve that? I also tried such scenario, but my packets always get dropped or didn't reach the VPS.
I have a openVZ host running racoon. I can establish a connection and the vpn client can ping the host's virtual bridge vmbr1 IP 10.0.2.254. But I can't reach/ping the VPS "behind" the virtual bridge with IP 10.0.2.123.
on "tcpdump -i eth0" in the VPS I can see the ICMP request, but there is no reply generated.
If I enter the VPS and ping the VPN client on 192.168.100.101 the ICMP packets are tunneled. I can see them on the VPN client with wireshark. A ICMP reply is generated, passes the tunnel and I can see it on the virtual bridge vmbr1 on the host ("tcpdump -i vmbr1") and inside the VPS ("tcpdump -i eth0"), but the ICMP replies got ignored or dropped?!?! --> no messages and 100% packet loss in the end.
best regards,
JD
|
|
|