OpenVZ Forum: Support » Disabling all limits

Home » General » Support » Disabling all limits

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Disabling all limits [message #35657 is a reply to message #35654]

Fri, 10 April 2009 10:31

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

Quote:

I think we have a misunderstanding here. In my case, the goal is to find out how much ressources are needed by my servers

The possible solution is to disable all limits at all. Wait for a "learning phase" and after that learn the "maxheld" column of /proc/user_beancounters output.

Quote:

So in this case I want each VE to give as much ressources as they need.

Why do you want to obtain the precise limits boundary then?
As far as I understand your scenario, you always increase barrier:limit values in case of failure. Why don't you switch off all limits?

Quote:

Just adding the "failcnt" value?

failcnt = failcounter. It's just a counter. So, if your application bumped into memory shortage and was refused to allocate virtual memory, failcounter increased by 1.

Report message to a moderator

[Message index]

		Disabling all limits By: divB on Wed, 08 April 2009 23:11
		Re: Disabling all limits By: maratrus on Thu, 09 April 2009 06:43
		Re: Disabling all limits By: divB on Thu, 09 April 2009 22:21
		Re: Disabling all limits By: maratrus on Fri, 10 April 2009 06:50
		Re: Disabling all limits By: divB on Fri, 10 April 2009 09:57
		Re: Disabling all limits By: maratrus on Fri, 10 April 2009 10:31
		Re: Disabling all limits By: divB on Fri, 10 April 2009 15:33

Previous Topic:	kernel/rhel5/028stab060.8 Kernel Compilation Error
Next Topic:	using /dev/ttyS0 inside a VM ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Sep 19 22:31:16 GMT 2026

Total time taken to generate the page: 0.07051 seconds