OpenVZ Forum


Home » General » Support » Access TVcard from vps?
Re: Access TVcard from vps? [message #35118 is a reply to message #35110] Mon, 02 March 2009 22:07 Go to previous message
argh is currently offline  argh
Messages: 6
Registered: June 2008
Junior Member
Well - it's not that hard really.

I've got 3 tuners installed on my server. These are all exposed to my container by the DEVNODES parameter. Basically I expose all the nodes in /dev/dvb (in the xxx.conf file).

I've installed a container with ubuntu 8.10 minimal openvz template, and then run apt-get install mythtv-server.

After that I install Freenx in the container, and connect to it to run mythtv-setup. Make sure the /dev/dvb/* are rw to the mythtv user. (Can also be done without freenx; if you're running X on another pc. (I'd love a text-based mythtv-setup!!))

I go through the setup, scan for channels on all cards and open the backend for remote access. (Set ip to real ip (not localhost), set pin to 0000).

As clients I use pc's with XBMC atlantis -> www.xbmc.org. (Native myth - support)

I have 2 clients running windows and xbmc, one running linux + xbmc and an xbox running xbmc. I also use mythtvplayer on my laptops. Currently working on getting easy access to video / livetv from my PDA and mobile.

I use mythtv as my only source of livetv - and sto schedule recordings.

As promised - I'll make a true howto; but it's gonna take some time. Small annoyances like work, wife and children tend to take up much of my time. Smile

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: upgrade kernel to see more than 4GB RAM
Next Topic: OpenVZ Clustering
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Nov 30 03:22:56 GMT 2025

Total time taken to generate the page: 0.61269 seconds
Powered by FUDforum Powered by Virtuozzo Containers