OpenVZ Forum: Support » vz startup message

Home » General » Support » vz startup message - is this a problem.

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

vz startup message - is this a problem. [message #3427]

Fri, 26 May 2006 20:38

vmvmvm
Messages: 51
Registered: January 2006

Member

When I start vz I get the message:

Configuring interface venet0: net.ipv4.conf.venet0.send_redirects = 0

Is this ok? I don't seem to recall getting that message on other servers where I've installed openvz.

Here's the full transcript:

/sbin/service vz start
Starting OpenVZ:                                           [  OK  ]
Bringing up interface venet0:                              [  OK  ]
Configuring interface venet0: net.ipv4.conf.venet0.send_redirects = 0
                                                           [  OK  ]

Report message to a moderator

Re: vz startup message - is this a problem. [message #3431 is a reply to message #3427]

Sat, 27 May 2006 04:07

Vasily Tarasov
Messages: 1345
Registered: January 2006

Senior Member

There is nothing to worry about.
I suppose, whether the text "net.ipv4.conf.venet0.send_redirects = 0" is present in output or not depends on sysctl version...
However, maybe is it better to make redirection to /dev/null in vz script to avoid this message? Rolling Eyes

We'll think about it. Thank you!

Report message to a moderator

Previous Topic:	SOLVED Unable to access VPS from network or network from VPS
Next Topic:	Compile software

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 28 19:21:30 GMT 2026

Total time taken to generate the page: 0.20206 seconds