OpenVZ Forum


Home » General » Support » [solved] opensuse11(VE) network failed
[solved] opensuse11(VE) network failed [message #34071] Sun, 30 November 2008 16:44 Go to previous message
tukey is currently offline  tukey
Messages: 10
Registered: March 2008
Location: China
Junior Member
Hi,
I wanted to migrate an openSUSE 11 from a physical server into a VE.
I did read some articles about "Physical to container" and "OpenSUSE template creation".
Then I copied everything from the physical server into /vz/private/XXXX, created a /etc/vz/conf/XXXX.conf with parameter IP_ADDRESS in it (here XXXX is my VEID).
And I disabled the VE's udev, created several necessary devices in /dev using mknod, modified /etc/fstab, linked /proc/mounts to /etc/mtab ... and so on.

By far, every is fine except network doen't work. I can't ping from or into the VE.

When I do a "ifconfig" inside the VE, nothing retrieved.
While when I do a "ifconfig -a", the result shows as below.
-------------------------------
# ifconfig -a
lo Link encap:Local Loopback
LOOPBACK MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

venet0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
BROADCAST POINTOPOINT NOARP MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
-------------------------------


So, can anyone help me or give a tip please?
Thank you.

[Updated on: Fri, 05 December 2008 09:34] by Moderator

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: how to find correct template for vps
Next Topic: Vlans on HN, how to disable routing between them
Goto Forum:
  


Current Time: Wed Aug 07 04:19:41 GMT 2024

Total time taken to generate the page: 0.02970 seconds