OpenVZ Forum: Support » Private/public IPs on VEs

Home » General » Support » Private/public IPs on VEs

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Private/public IPs on VEs [message #33981]

Sun, 23 November 2008 19:40

ktwalrus
Messages: 13
Registered: November 2008

Junior Member

I'm new to OpenVZ and from reading over the pages here, I think I basically understand some of the issues to do what I want, but I'd like to read opinions since I haven't seen an article specifically address my set up.

I have a server (HN) that has two ethernet ports: eth0 and eth1. eth0 is for Private VLAN and eth1 is for Public Internet.

I have 5 Public IPs (4 usable for VEs) and 64 Private IPs (63 usable for VEs).

I want to create the VEs so some of them have a Public IP and all of them have a Private IP. All of them should be able to see all VEs and HN. The HN has both a public and a private IP. All of them should be able to see the internet including seeing the DNS servers. The internet should only see the VEs with Public IPs.

Report message to a moderator

Re: Private/public IPs on VEs [message #33994 is a reply to message #33981]

Mon, 24 November 2008 13:24

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

Hello,

it is a possible scenario.

You may use either venet interface or veth inside VE.
I'll try to describe in a few words venet case. You can read more about veth interface at the following page http://wiki.openvz.org/Veth .

- set appropriate sysctl parameters for example as described
http://wiki.openvz.org/Quick_installation#sysctl
- to assign an ip address to your VE use "vzctl set $VEID --ipadd $IP [-save]"
- make sure that default gateway inside each VE pointed to venet interface. you can also set explicit routes inside VE i.e.
ip route add $PRIAVTE_NETWORK src $PRIVATE_IP dev venet0
ip route add $PUBLIC_NETWORK src $PUBLIC_IP dev venet0
- to provide an access to internet for your "private" VEs you can use SNAT
http://wiki.openvz.org/Using_NAT_for_container_with_private_ IPs

Report message to a moderator

Re: Private/public IPs on VEs [message #33999 is a reply to message #33994]

Tue, 25 November 2008 04:24

ktwalrus
Messages: 13
Registered: November 2008

Junior Member

Thanks. I got it mostly working.

Report message to a moderator

Re: Private/public IPs on VEs [message #34004 is a reply to message #33999]

Tue, 25 November 2008 09:05

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

Hello,

just to be more fair and precise.
I was pointed out that my previous post was not correct. The suggestion to put route like

ip route add $PUBLIC_NETWORK src $PUBLIC_IP dev venet0

in some cases is meaningless. The better way to give an access to internet is

ip route add default dev venet0 src $PUBLIC_IP

Report message to a moderator

Previous Topic:	Setting Resource Limit's
Next Topic:	[solved] Checkpointing does not work ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Sep 19 07:46:13 GMT 2026

Total time taken to generate the page: 0.06905 seconds