OpenVZ Forum


Home » General » Support » Can't start networking on a fedora-9-i386-default-20080913 VE
Re: Can't start networking on a fedora-9-i386-default-20080913 VE [message #33039 is a reply to message #33034] Thu, 18 September 2008 19:11 Go to previous messageGo to previous message
kwessel is currently offline  kwessel
Messages: 4
Registered: September 2008
Junior Member
So, the kernel I grabbed from git doesn't seem to boot.

yum install git ('cause it didn't have it on the HN)
cd /usr/src
git clone git://git.openvz.org/pub/linux-2.6.24-openvz
cd linux-2.6.24-openvz
zcat /proc/config.gz >.config
make oldconfig (because I'm paranoid)
make -j2
(was successful
make modules_install

Backed up the old kernel

cd /boot
mv vmlinuz-2.6.24-ovz005.1 vmlinuz-2.6.24-ovz005.1.old
mv vmlinux-2.6.24-ovz005.1 vmlinux-2.6.24-ovz005.1.old
mv System.map-ovz005.1 System.map-ovz005.1.old

Then installed the new kernel:

cp /usr/src/linux-2.6.24-openvz/arch/i386/boot/bzImage vmlinuz-2.6.24-ovz005.1
cp /usr/src/linux-2.6.24-openvz/System.map System.map-ovz005.1

I didn't move or replace the initrd. Note that I moved the vmlinux (not vmlinuz), but didn't replace it.

Kernel seems to panic and won't boot (though I can't tell any details as it's in the datacenter and I'm half way across the country from it. Wink )

Did I not compile this baby correctly?

Thanks,
Keith

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Strange networking problem
Next Topic: VE IP address stops working after several hours
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Feb 18 07:16:55 GMT 2026

Total time taken to generate the page: 0.30755 seconds
Powered by FUDforum Powered by Virtuozzo Containers