OpenVZ Forum: Support » Memory limits in active VE

Home » General » Support » Memory limits in active VE - refreshing info in VE system?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Memory limits in active VE - refreshing info in VE system? [message #32998]

Tue, 16 September 2008 15:11

januszzz
Messages: 50
Registered: January 2007
Location: Opole, Poland

Member

Hi,
I'm setting memory limits in active VE. Everything works OK, settings appears immediately in /proc/user_beancounters.

But the question is if I should also see extended/decreased parameters when I run 'free' command? I do see old parameters until I reboot the VE.

Is it a way to refresh this in free and/or cat /proc/meminfo output?

Report message to a moderator

Re: Memory limits in active VE - refreshing info in VE system? [message #32999 is a reply to message #32998]

Tue, 16 September 2008 18:57

xemul
Messages: 248
Registered: November 2005

Senior Member

The things you see in /proc/meminfo depends on the --meminfo <mode> you used for your ve.

Can you provide some more detail on the problems you have - ve config file, free outputs, vzctl set commands you type, etc.

http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

Re: Memory limits in active VE - refreshing info in VE system? [message #33001 is a reply to message #32999]

Tue, 16 September 2008 19:28

januszzz
Messages: 50
Registered: January 2007
Location: Opole, Poland

Member

--meminfo you say... so RTFM just helped... Cool

It appears that if I change privvmpages/kmemsize values of /proc/meminfo are not in line with real memory setting until the VE reboot, this is my issue.

I've changed --meminfo to pages:value which is appripriate for real memory assigned to VE. After reboot of the VE this setting will revert, but free will show correct (privvmpages) information.

Do I get it right, should it be like that?

Configs are usual, I just didn't know the meminfo option... strange, I've read the manual three years ago Wink

Report message to a moderator

Re: Memory limits in active VE - refreshing info in VE system? [message #35951 is a reply to message #33001]

Wed, 06 May 2009 04:11

bbhenry
Messages: 17
Registered: February 2009

Junior Member

I have the same issue. And this is happening to my installation on a Ubuntu 8.04 64 bit Hardware Node.

My other CentOS based Hardware Node don't have this issue. What ever memory I assigned to the VE, the "free" command inside VE will reflect right away my changes.

So I am wondering if this is a bug of the Ubuntu 8.04 OpenVZ kernel?

Report message to a moderator

Previous Topic:	OpenVZ on Ubuntu 9.04 (Jaunty) Host
Next Topic:	updated from centos 5.2 to 5.3, yum error now on VEs

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Feb 06 20:35:45 GMT 2026

Total time taken to generate the page: 0.48197 seconds