OpenVZ Forum: Support » Nat inside VE

Home » General » Support » Nat inside VE - openvpn again

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Nat inside VE - openvpn again [message #32099 is a reply to message #32095]

Mon, 21 July 2008 09:46

mperkel
Messages: 253
Registered: December 2006

Senior Member

If I run this at the command line it works after restarting the vz service:

modprobe ip_nat
modprobe xt_tcpudp
modprobe ip_conntrack ip_conntrack_enable_ve0=1

How do I get these modules to load on startup?

Junk Email Filter
http://www.junkemailfilter.com

Report message to a moderator

[Message index]

		Nat inside VE - openvpn again By: mperkel on Mon, 21 July 2008 08:37
		Re: Nat inside VE - openvpn again By: mperkel on Mon, 21 July 2008 09:46
		Re: Nat inside VE - openvpn again By: kir on Mon, 21 July 2008 11:22
		Re: Nat inside VE - openvpn again By: kir on Mon, 21 July 2008 11:25
		Re: Nat inside VE - openvpn again By: mperkel on Mon, 21 July 2008 17:09
		Re: Nat inside VE - openvpn again By: mperkel on Mon, 21 July 2008 17:48
		Re: Nat inside VE - openvpn again By: kir on Tue, 22 July 2008 07:04
		Re: Nat inside VE - openvpn again By: mperkel on Tue, 22 July 2008 07:28
		Re: Nat inside VE - openvpn again By: kir on Tue, 22 July 2008 07:45

Previous Topic:	Transfer rate from inside container?
Next Topic:	netdev_add under debian : how to configure device after

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Sep 18 06:35:38 GMT 2026

Total time taken to generate the page: 0.74688 seconds