OpenVZ Forum


Home » General » Support » Network configuration
Network configuration [message #31412] Fri, 27 June 2008 16:09 Go to previous message
erojasv is currently offline  erojasv
Messages: 1
Registered: June 2008
Junior Member
Hello, i am starting with openvz, i installed it in a Gentoo Server, and i have to configure the vps with the two physics networks device that i have in my server, by default the vps(Debian) get the venet0:0 for the LAN (192.168.22.0) but i have to activate the eth1 that have the ip public for my server, i tried with:

# vzctl set 101 --netdev_add eth1 --save
but it deactivate the eth1 card of my server, what other way can i try to actiavte this card?

Thanks

Report message to a moderator

[Message index]
 
Read Message
Read Message
Previous Topic: Is it possible to postpone/schedule the vzquota recalculation (after HN power failures etc)?
Next Topic: Feisty VE breaks Edgy HN
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Nov 04 02:29:05 GMT 2025

Total time taken to generate the page: 0.17731 seconds
Powered by FUDforum Powered by Virtuozzo Containers