OpenVZ Forum: Support » Network configuration

Home » General » Support » Network configuration

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Network configuration [message #31412]

Fri, 27 June 2008 16:09

erojasv
Messages: 1
Registered: June 2008

Junior Member

Hello, i am starting with openvz, i installed it in a Gentoo Server, and i have to configure the vps with the two physics networks device that i have in my server, by default the vps(Debian) get the venet0:0 for the LAN (192.168.22.0) but i have to activate the eth1 that have the ip public for my server, i tried with:

# vzctl set 101 --netdev_add eth1 --save
but it deactivate the eth1 card of my server, what other way can i try to actiavte this card?

Thanks

Report message to a moderator

Re: Network configuration [message #31513 is a reply to message #31412]

Wed, 02 July 2008 11:35

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

Hello,

could you please specify your task.
Do you want to assign a particular IP address to your VE?
Why don't you use
vzctl set VE_ID --ipadd x.x.x.x ?

Report message to a moderator

Previous Topic:	Is it possible to postpone/schedule the vzquota recalculation (after HN power failures etc)?
Next Topic:	Feisty VE breaks Edgy HN

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 05 21:09:11 GMT 2026

Total time taken to generate the page: 0.19408 seconds