OpenVZ Forum: Users » cani install OpenVZ remotely

Home » Mailing lists » Users » cani install OpenVZ remotely

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

cani install OpenVZ remotely [message #3087]

Thu, 11 May 2006 18:14

abhishek jain
Messages: 9
Registered: May 2006

Junior Member

Dear Friends,
I need to install OpenVZ remotely ie with no physical access to the
server(Linux) .
Can i do that and run it efficiently.
If yes than also tell me how to install it , I can find the documentation on
the site but any tip will be handy.
Also tell me will mine customers get a control panel when i install OpenVZ
apart from cpanel / Plesk.

Thanks,
Abhishek Jain

Report message to a moderator

Re: cani install OpenVZ remotely [message #3088 is a reply to message #3087]

Thu, 11 May 2006 18:53

Martin Braun
Messages: 6
Registered: February 2006

Junior Member

Of course you can, just download a RPM kernel image and the ovz tools
or compile a vanilla kernel with patches on the system and replace the
exisiting kernel. There is no need to have physical access to the host,
a remote shell connection is all you need. But be careful with the a
vanilla kernel configuration, wrong settings may result in system hang
while booting the new ovz enabled kernel.

greetings

martin

abhishek jain wrote:
> Dear Friends,
> I need to install OpenVZ remotely ie with no physical access to the
> server(Linux) .

Report message to a moderator

Re: cani install OpenVZ remotely [message #3094 is a reply to message #3088]

Fri, 12 May 2006 07:21

dev
Messages: 1693
Registered: September 2005
Location: Moscow

Senior Member

Also, check that:

1. you have conntrack firewall disabled on the host or add:
options ip_conntrack ip_conntrack_enable_ve0=1
to your /etc/modprobe.conf

2. you have disabled SElinux in /etc/selinux/config:
SELINUX=disabled

Kirill

> Of course you can, just download a RPM kernel image and the ovz tools
> or compile a vanilla kernel with patches on the system and replace the
> exisiting kernel. There is no need to have physical access to the host,
> a remote shell connection is all you need. But be careful with the a
> vanilla kernel configuration, wrong settings may result in system hang
> while booting the new ovz enabled kernel.
>
> greetings
>
> martin
>
> abhishek jain wrote:
>
>> Dear Friends,
>> I need to install OpenVZ remotely ie with no physical access to the
>> server(Linux) .
>

Report message to a moderator

Previous Topic:	How many VM on a Host
Next Topic:	how to make an exact copy of the VPS

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 17 04:58:20 GMT 2025

Total time taken to generate the page: 1.17732 seconds