Re: Accessing PCI Devices from VE [message #30855 is a reply to message #30850] |
Mon, 09 June 2008 10:52 |
Kirill Shileev
Messages: 6 Registered: December 2007
|
Junior Member |
|
|
In general, it should be possible to get access to analog telephony drivers by that the same technique like in case of ztdummy. You need:
1. install kernel drivers for your device on HN in usual way:
put your *.ko to /lib/modules/you_kernel and then modprobe you_module_name
2. declare it visible in relevant CT by
vzctl set CTID --devnodes you_device_file_name:rw --save.
Here's imperative to remember that device drivers are to be loaded on HN, in CT it's not allowed, while Asterisk software will perfectly run in CT.
That's it. But, please, take a note, that I never tested this since I don't have the corresponding hardware.
Kirill
|
|
|