OpenVZ Forum


Home » General » Support » Source based routing
Re: Source based routing [message #29070 is a reply to message #28818] Fri, 04 April 2008 10:57 Go to previous messageGo to previous message
maratrus is currently offline  maratrus
Messages: 1495
Registered: August 2007
Location: Moscow
Senior Member
Hi,

I'm terribly sorry for delay.
Did you solve this problem?

1. You wrote
Quote:


if i run

arpsend -U -i VE_IP -c 1 eth0


So i've ran '/usr/sbin/arpsend -U -i 67.xxx.xxx.140 -c 1 eth1'



So does it matter if you use eth0 or eth1 interfaces?

2. As a suggestion:
When it stops working please look at arp-table on the external node ("arp -n") and try to find the record with the VE_IP address (67.xxx.xxx.140) then please try to "ip r get 67.xxx.xxx.140". So you can find out where this package goes, I suppose that it goes through the default gateway (default gateway of the external node). You can observe where the package goes with tcpdump utility with the "-e" option which allows us to look at MAC addresses. That is why I think we should look at the default gateway (of the external node) behavior.

3.
Quote:


Nothing, a traceroute won't reach the VE IP, it dies at the switch



What interface did you listen with tcpdump. Try to specify it with -i parameter. Please listen both eth0 and eth1 interfaces. Does nothing come to both of them?

4. And another question:
Do your eth0 and eth1 interfaces connect to different switches?
Are 69.xxx.xx0.129 and 67.xxx.xxx.129 different nodes?

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Problem dcachesize
Next Topic: Can't remove VPS
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Sep 04 23:34:59 GMT 2026

Total time taken to generate the page: 0.05146 seconds
Powered by FUDforum Powered by Virtuozzo Containers