i can log into my virtual machine from the host machine but not from remote computers. i can log into the host machine from remote computers though.
i added the ip 192.168.0.4 to the host machine at first (yes this is all on a private network) and then added the ip 192.168.0.5 to the virtual machine. a full restart later and no luck.
i then added the ip 192.168.0.5 as a secound ip to the host machine by creating the file
ifcfg-eth0:1
the contense of the file are as fwollows
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=192.168.0.5
NETMASK=255.255.255.0
GATEWAY=192.168.0.1
i noticed that the ifcfg-venet0 file on the host machine contains this code:
DEVICE=venet0
ONBOOT=yes
STARTMODE=onboot
is this normal or should this contain more information.
here is the output from the ifconfig command on the virtual machine.
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:4132306944 errors:0 dropped:0 overruns:0 frame:0
TX packets:4096 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
venet0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00 -00
inet addr:127.0.0.1 P-t-P:127.0.0.1 Bcast:0.0.0.0 Mask:255.255.255. 255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:102 errors:0 dropped:0 overruns:0 frame:0
TX packets:71 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:8686 (8.4 KiB) TX bytes:8091 (7.9 KiB)
venet0:0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00 -00
inet addr:192.168.0.6 P-t-P:192.168.0.6 Bcast:192.168.0.6 Mask:255. 255.255.255
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
seems kins jumbeled if you ask me. this is where i think the error is.
to add the ip i used the command
vzctl set 102 --ipadd 192.168.0.5 --save
any help is always greatly apriciated.
[Updated on: Sun, 03 February 2008 23:29]
Report message to a moderator