OpenVZ Forum


Home » General » Support » *SOLVED* Ubuntu VE + working IPv6
Re: Ubuntu VE + working IPv6 [message #25379 is a reply to message #25378] Fri, 21 December 2007 12:23 Go to previous messageGo to previous message
broquea is currently offline  broquea
Messages: 20
Registered: December 2007
Junior Member
curx wrote on Fri, 21 December 2007 03:50

Have you added the IPv6 Support, while the VE is running ?
so please (Re-)Start the VE.




Ok, clarifications:

IPv6 support was set in vz.conf before any VE was created.

I've restarted the Ubuntu VE several times, to no avail.
I've restarted the overall service a few times as well (/etc/init.d/vz).

IPv6 is working in the 3 RedHat based VEs.

IPv6 is not working in the Debian based Ubuntu VE.

It isn't an ip6tables issue because the ipv6 address isn't being applied to the interface.

I can manually configure the ipv6 address on the interface using ifconfig, without errors. However routing is another issue and I need to read more on the whole venet device a bit more to figure out what specific route statement was done under the RedHat based VEs, as it is working.

FC8 VE:
route -A inet6
Kernel IPv6 routing table
Destination                                 Next Hop                                Flags Metric Ref    Use Iface
fe80::/64                                   *                                       U     256    0        0 venet0
*/0                                         *                                       U     1      0        0 venet0
::1/128                                     *                                       U     0      1        1 lo
a:b:c::d/128                                *                                       U     0      19       1 lo
ff00::/8                                    *                                       U     256    0        0 venet0


Ubuntu 7.10 VE (with manual configuration of address onto venet0):
route -A inet6
Kernel IPv6 routing table
Destination                                 Next Hop                                Flags Metric Ref    Use Iface
fe80::/64                                   ::                                      U     256    0        0 venet0
::1/128                                     ::                                      U     0      9        1 lo
a:b:c::d/128                                ::                                      U     0      0        1 lo
ff00::/8                                    ::                                      U     256    0        0 venet0

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: disk quota exceeded problem at ve
Next Topic: Installation on VPS fails....
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Aug 19 19:28:40 GMT 2026

Total time taken to generate the page: 0.95052 seconds
Powered by FUDforum Powered by Virtuozzo Containers