OpenVZ Forum: Support » Multiple (2) Network Cards both used for VE's + Public IP issues

Home » General » Support » Multiple (2) Network Cards both used for VE's + Public IP issues

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Multiple (2) Network Cards both used for VE's + Public IP issues [message #24172]

Sun, 02 December 2007 10:51

stuartornum
Messages: 21
Registered: February 2007

Junior Member

Hi,

I haven't yet implemented this yet, but just wanted to know if there is any issues and setup difference I would need to know.

I have only used OpenVZ in a local network environment, so local IP's only. But when I put the server into my local DC im a bit confused about the public IP's of VE's.

So lets say I have IP range 80.1.1.10 -> 80.1.1.20

Hardware Node assigned 80.1.1.10 for eth0 and 80.1.1.11 for eth1.

Do I need to create eth0:0, eth0:1, eth0:2 for 80.1.1.12, 80.1.1.13 and 80.1.1.14 respectively on the HN? As im not quite sure how the VE's use the public IP's.

Also, as you can see from above I have two network cards.

Ideally I would like to have some on eth0 and others on eth1..

Would this be hard to achieve?

Thank you in advance

Report message to a moderator

[Message index]

		Multiple (2) Network Cards both used for VE's + Public IP issues By: stuartornum on Sun, 02 December 2007 10:51
		Re: Multiple (2) Network Cards both used for VE's + Public IP issues By: khorenko on Mon, 03 December 2007 08:45

Previous Topic:	How to run OSPF inside VE? (or: multicast support in VE in general)
Next Topic:	NFS - Connection Refused.. (Common-Error in Uncommon Form)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 17 06:05:20 GMT 2024

Total time taken to generate the page: 0.09961 seconds