OpenVZ Forum


Home » General » Support » Unable to run OpenVPN - "openvpn --mktun --dev tap0" fails
Re: Unable to run OpenVPN - "openvpn --mktun --dev tap0" fails [message #23992 is a reply to message #22011] Thu, 29 November 2007 18:44 Go to previous messageGo to previous message
tomfra is currently offline  tomfra
Messages: 28
Registered: September 2007
Junior Member
Instead of this line:

/sbin/iptables -t nat -A POSTROUTING -s ! x.x.x.x -o venet0 -j SNAT --to-source x.x.x.x

try this one:

/sbin/iptables -t nat -A POSTROUTING -s 10.88.0.0/16 -o venet0 -j SNAT --to-source 192.168.1.5

where 10.88.0.0/16 is the internal IP range assigned by OpenVPN, you will very likely have a different one so don't forget to change it.

I am not saying it will work, I am really not a "pro" in this field, but it may be worth a try.

Tomas

Do you really believe the Internet is a safe place?
IdentityCloaker.com - Take Back Your Privacy!

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: *SOLVED* No Internet access on VEs (but I get remote SSH access)
Next Topic: Warning: Variable TEMPLATE not found in /etc/sysconfig/vz
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Aug 25 12:48:08 GMT 2026

Total time taken to generate the page: 0.40476 seconds
Powered by FUDforum Powered by Virtuozzo Containers