OpenVZ Forum: Support » Networking? (NAT)

Home » General » Support » Networking? (NAT)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Networking? (NAT) [message #23331 is a reply to message #23309]

Thu, 15 November 2007 14:48

RobinVossen
Messages: 36
Registered: November 2007

Member

THanks for your support. But I think I am thick or something...
I did run the following commands:
vzctl start 1
iptables -t nat -A POSTROUTING -s 192.168.1.1 -o eth0 -j SNAT --to 192.168.42.112
After that I did run vzlist output:
VPSID 1 NPROC 1 STATUS running IP_ADDR 192.168.1.1 HOSTNAME 1
Then I did vzctl enter 1
Now ping google.com (Error, unknown host google.com)
Exit (to get to my main system) ping google.com (Success)
ifconfig afterwards to check if I really aws 192.168.42.112.
Output:
eth0 inet addr:192.168.42.112

Bad Luck..

Were do I go wrong? Sad

Report message to a moderator

[Message index]

		Networking? (NAT) By: RobinVossen on Thu, 15 November 2007 08:22
		Re: Networking? (NAT) By: vaverin on Thu, 15 November 2007 11:48
		Re: Networking? (NAT) By: RobinVossen on Thu, 15 November 2007 12:56
		Re: Networking? (NAT) By: vaverin on Thu, 15 November 2007 13:18
		Re: Networking? (NAT) By: RobinVossen on Thu, 15 November 2007 14:48
		Re: Networking? (NAT) By: khorenko on Thu, 15 November 2007 15:06
		Re: Networking? (NAT) By: khorenko on Thu, 15 November 2007 15:08
		Re: Networking? (NAT) By: RobinVossen on Thu, 15 November 2007 15:14
		Re: Networking? (NAT) By: RobinVossen on Thu, 15 November 2007 15:18
		Re: Networking? (NAT) By: khorenko on Fri, 16 November 2007 09:56

Previous Topic:	compiling kernel 2.6.8.1, net/ipv6/route.c: Error: request for member `lock' in something
Next Topic:	Help with port to ARM architecture

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Feb 18 19:24:39 GMT 2026

Total time taken to generate the page: 0.17875 seconds