OpenVZ Forum


Home » General » Support » VZ networking/routing
Re: VZ networking/routing [message #232 is a reply to message #231] Sun, 16 October 2005 14:28 Go to previous messageGo to previous message
slhost is currently offline  slhost
Messages: 3
Registered: October 2005
Junior Member
The thing that boggles my mind is how you can reach VZPP on the IP assigned to a VE when the VE isn't mounted. I've tried setting up a virtual network device like VZ does including setting up the route with a src IP of that virtual device and sent out arp notices as well like I see they do. Nothing I do allows me to trace the IP to the src IP. I'm just trying to get a grip on this because it's very interesting to me. Below are commands I've used to test this.

1. Create a virtual device first, we'll call it virt0 and bring it up.
2. ip route add 192.168.1.2 dev virt0 src 192.168.1.3
3. ip neigh add proxy 192.168.1.2 dev eth0
4. /usr/sbin/arpsend -c 1 -w 1 -U -i 192.168.1.2 -e 192.168.1.2 virt0

Perhaps this goes beyond the discussions of this board, but I thought someone might know here how exactly to set something like this up for an example of how it works with VZ.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Problem on Disk Quota 100% used and df
Next Topic: Few questions about the released updates for openvz
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Nov 10 08:47:33 GMT 2026

Total time taken to generate the page: 0.63690 seconds
Powered by FUDforum Powered by Virtuozzo Containers