| Re: IPCop template [message #22760 is a reply to message #22720] |
Fri, 02 November 2007 21:22   |
nschembr
Messages: 5
Registered: October 2007
Location: pa usa
|
Junior Member |
|
|
Help. Ok, I'm stuck.
Hardware node# ipconfig
77g-br Link encap:Ethernet HWaddr 00:18:51:8C:B1:31
inet addr:10.200.1.20 Bcast:10.200.1.255 Mask:255.255.255.0
inet6 addr: fe80::218:51ff:fe8c:b131/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2 errors:0 dropped:0 overruns:0 frame:0
TX packets:11 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:56 (56.0 b) TX bytes:902 (902.0 b)
br0 Link encap:Ethernet HWaddr 00:18:51:D4:35:40
inet addr:192.168.1.202 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::21c:c0ff:fe05:a51/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:16831 errors:0 dropped:0 overruns:0 frame:0
TX packets:9324 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:24588860 (23.4 MiB) TX bytes:660477 (644.9 KiB)
eth1 Link encap:Ethernet HWaddr 00:1C:C0:05:0A:51
inet6 addr: fe80::21c:c0ff:fe05:a51/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:16830 errors:0 dropped:0 overruns:0 frame:0
TX packets:10288 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:24892265 (23.7 MiB) TX bytes:794884 (776.2 KiB)
Base address:0x30e0 Memory:e0300000-e0320000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
venet0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
UP BROADCAST POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
veth101.0 Link encap:Ethernet HWaddr 00:18:51:D4:35:40
inet6 addr: fe80::218:51ff:fed4:3540/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:46 errors:0 dropped:0 overruns:0 frame:0
TX packets:55 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4735 (4.6 KiB) TX bytes:4837 (4.7 KiB)
veth104.0 Link encap:Ethernet HWaddr 00:18:51:8C:B1:31
inet6 addr: fe80::218:51ff:fe8c:b131/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:996 errors:0 dropped:0 overruns:0 frame:0
TX packets:170 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:83173 (81.2 KiB) TX bytes:11963 (11.6 KiB)
veth105.0 Link encap:Ethernet HWaddr 00:18:51:DE:9A:89
inet6 addr: fe80::218:51ff:fede:9a89/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:936 errors:0 dropped:0 overruns:0 frame:0
TX packets:60 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:74816 (73.0 KiB) TX bytes:3512 (3.4 KiB)
veth105.1 Link encap:Ethernet HWaddr 00:18:51:CF:F1:7D
inet6 addr: fe80::218:51ff:fecf:f17d/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:154 errors:0 dropped:0 overruns:0 frame:0
TX packets:988 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:10067 (9.8 KiB) TX bytes:80629 (78.7 KiB)
hardware node#route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.200.1.0 * 255.255.255.0 U 0 0 0 77g-br
192.168.1.0 * 255.255.255.0 U 0 0 0 br0
default 192.168.1.1 0.0.0.0 UG 0 0 0 br0
Hardware node# brctl show
bridge name bridge id STP enabled interfaces
77g-br 8000.0018518cb131 no veth105.1
veth104.0
br0 8000.001851d43540 no eth1
veth101.0
veth105.0
Smoothwall
fw77 (root) / $ ifconfig
eth0 Link encap:Ethernet HWaddr 00:18:51:EB:A2:3F
inet addr:192.168.1.212 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::218:51ff:feeb:a23f/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:75 errors:0 dropped:0 overruns:0 frame:0
TX packets:1338 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4166 (4.0 Kb) TX bytes:107856 (105.3 Kb)
eth1 Link encap:Ethernet HWaddr 00:18:51:55:11:34
inet addr:10.200.1.1 Bcast:10.200.1.255 Mask:255.255.255.0
inet6 addr: fe80::218:51ff:fe55:1134/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1386 errors:0 dropped:0 overruns:0 frame:0
TX packets:163 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:113557 (110.8 Kb) TX bytes:10319 (10.0 Kb)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:33 errors:0 dropped:0 overruns:0 frame:0
TX packets:33 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3016 (2.9 Kb) TX bytes:3016 (2.9 Kb)
RX bytes:3016 (2.9 Kb) TX bytes:3016 (2.9 Kb)
fw77 (root) / $ route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
10.200.1.0 * 255.255.255.0 U 0 0 0 eth1
default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
fw77 (root) / $
The fw can access 192.168.1.1. and the internet.
The VE host
root@localhost:/# ifconfig
eth0 Link encap:Ethernet HWaddr 00:18:51:27:7F:0A
inet addr:10.200.1.25 Bcast:10.200.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:185 errors:0 dropped:0 overruns:0 frame:0
TX packets:1602 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:12383 (12.0 KiB) TX bytes:133237 (130.1 KiB)
root@localhost:/# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.200.1.0 * 255.255.255.0 U 0 0 0 eth0
default fw77 0.0.0.0 UG 0 0 0 eth0
root@localhost:/#
The ve host can access 192.168.1.202, 192.168.1.212 , and 10.200.1.1. but not 192.168.1.1
If I run tcpdump on the hardware node and i ping 192.168.1.1, I can see the traffic from host 10.200.1.25. This sounds like the nat on smoothwall is not working.
Diag test1 diag.pdf is true. I have changed 10.200.50.0/24 to 192.169.1.0/24 for testing.
How do you I turn on Nat inside the ve?
Nicholas A. Schembri
State College PA USA
|
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
