| Re: Using the same IP as VPS0 (HOST) [message #2257 is a reply to message #2255] |
Mon, 27 March 2006 21:19   |
dearaujo
Messages: 6
Registered: March 2006
|
Junior Member |
|
|
Ok - I tried your suggestion, but I can't seem to get it to work. Here's my configuration:
Hardware Node public IP - w.x.y.z (keeping it to myself atm) 
VPS private IP - 192.168.0.1
IP route commands - (trying to run a web server - port 80):
iptables -t nat -A PREROUTING -p tcp -d w.x.y.z --dport 80 -j DNAT --to-destination 192.168.0.1
iptables -t nat -A POSTROUTING -s 192.168.0.1 -j SNAT --to-source w.x.y.z
# iptables -nvL -t nat
Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain POSTROUTING (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
0 0 SNAT all -- * * 192.168.0.1 0.0.0.0/0 to:w.x.y.z
Chain PREROUTING (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
0 0 DNAT tcp -- * * 0.0.0.0/0 w.x.y.z tcp dpt:80 to:192.168.0.1
Also, my nameserver in my VPS matches my Hardware Nodes' nameserver.
I can ping w.x.y.z from inside my VPS. I can ping my VPS from my hardware node. However, I _cannot_ ping anything other than my hardware node nor can I access the test webpage from outside the VPS.
Any suggestions?
[Updated on: Mon, 27 March 2006 21:24] Report message to a moderator |
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
