OpenVZ Forum: Support » using network aliases

Home » General » Support » using network aliases

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: using network aliases [message #2016 is a reply to message #2014]

Tue, 14 March 2006 16:44

bhazeltn
Messages: 5
Registered: March 2006

Junior Member

Ok, now I'm stumped again.
I removed eth0:2 from my network config. The IP was already assigned to the vps. The vps starts fine. I go to ping the IP and I get no response.

I do have /etc/sysctl.conf set up according to the quick install directions (however they are not in the gentoo howto)

I'm using Gentoo, which I figure probably makes this crap out on me

Report message to a moderator

[Message index]

		using network aliases By: bhazeltn on Tue, 14 March 2006 12:05
		Re: using network aliases By: kir on Tue, 14 March 2006 13:31
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 15:51
		Re: using network aliases By: kir on Tue, 14 March 2006 15:57
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 16:44
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 17:53
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 16:07

Previous Topic:	Question about memory resource parameters
Next Topic:	iptables in vps or on the host node

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Aug 30 12:44:39 GMT 2026

Total time taken to generate the page: 0.51930 seconds