OpenVZ Forum: Support » How can I bind a VE IP address to a physical ethernet interface?

Home » General » Support » How can I bind a VE IP address to a physical ethernet interface?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How can I bind a VE IP address to a physical ethernet interface? [message #20100 is a reply to message #20096]

Wed, 12 September 2007 08:21

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

Hi,
you can solve your problem by using bridges:

Let's assume, that you have two interfaces eth0, eth1 on your HN and two VEs(VE101, VE102)

1.Use veth instead of venet.
http://wiki.openvz.org/Veth
http://wiki.openvz.org/Differences_between_venet_and_veth

2. You can bind VE101's network traffic to eth0 and VE102's to eth1 by creating veth101.0, veth102.0 interfaces and then creating two bridges uniting eth0,veth101.0 and eth1,veth102.0.

Report message to a moderator

[Message index]

		How can I bind a VE IP address to a physical ethernet interface? By: fgomes on Tue, 11 September 2007 22:47
		Re: How can I bind a VE IP address to a physical ethernet interface? By: maratrus on Wed, 12 September 2007 08:21

Previous Topic:	Problems suspending VE with 2.6.18-028stab039
Next Topic:	kernel: EDAC k8 MC0: GART TLB errorr: transaction type(generic), cache level(generic)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Jul 16 03:21:50 GMT 2026

Total time taken to generate the page: 0.12793 seconds